Miller Big Blue 400X Pro with ArcReach

Allows the arc characteristics to be changed for specific applications in Stick, TIG, MIG and FCAW.

Detects if a remote control is plugged into the 14-pin receptacle and eliminates confusion of a remote/panel switch.

Reduces the open-circuit voltage to 30 volts when the welding power source is not in use. This feature is now built into the Big Blue 400X Pro for increased operator safety without compromising arc starts.

SunVision technology enables welding parameters to be viewed with greater clarity than analogue meters at virtually any angle. Meters can be seen clearly even in direct sunlight.

• 1 x 240 V 60Hz 32 Amp 1 Phase Socket.
• 2 x 240 V 60 Hz 15 Amp 1 Phase Socket.
• RCD.

*Generator auxiliary power is 60Hz, and intended for operating equipment associated with welding, such as angle grinders, drills and floodlights. Some Australian 50Hz equipment incorporating induction motors, such as pumps, fans, air compressors, refrigeration or airconditioners, may not operate correctly and could be damaged. Refer to appliance supplier or manufacturer to confirm suitability.